Check the following

1. Is the power turned on at the wall, is the plug all the way in

2. Check the power switch on the panel, this will be next to where the power lead is plugged into the panel

3. once both these are checked, you should have a red indicator light on the bottom right hand corner of the panel

4. Turn on the panel, the indicator light should go orange or green depending on the model

 

1. Check power cable is not loose, ensure plugged firmly into socket on screen

2. Check power switch on screen next to power socket, ensure in the on position

3. Once the switch is on you should have a power indicator light on the bottom right hand corner of the screen

4. Indicator light should be Red

5. press the power button on the screen, Indicator light should turn either orange or green and panel should turn on

6. if no indicator light after all these points are checked, try a different power lead to confirm lead is not the cause

once a new lead has bee tried if still no power,

contact Warranty Support

1. Gently press the power button and check that it moves in slightly, there should be a clicking noise when pressed

2. Remove the power lead from the panel,

Press and hold the power button for 10 seconds,

Reconnect the power lead and press the power button on the panel,

If it still stays red,

Contact our Support Team

Content 1

 

Content 2

 

Content 3

 

Content 4

 

Use the remote to adjust the brightness on the panel

 

if using a HDMI cable

1. Check for damage to the cable

2. check cable length is not too long -- try a shorter cable

3. check the settings on your laptop or PC - battery saving, low power settings,

 

Interactive touch requires a USB cable to be connected to the panel from yoir PC or Laptop

Check connectons on the USB cable,

ensure USB cable not damaged

If using the front ports on the panel, check that the USB cable is plugged into the port labelled USB touch

 

Check that your PC or laptop resolution is set correctly, should be 1920 x 1080p or higher

Check that the display completely fills the screen, if there is a gap at either side then the resolution is incorrect

if the resolution is correcct and the picture fills the screen, you may need to recalibrate the touch

Instructions for recalibrating - Click here